Hello, I was trying to find in the forum the "old" instructions to update the firmware and could not find it. In order to enter debug mode you enter 192.168.4.1:82 instead of 192.168.4.1 and you follow instructions. Basically you need to point to the BIN file that you update to, press update and wai...

Hello, Thank you for your detailed report. Unfortunately I am in Turkey and I have limited (or none) capacity to repeat your tests. There have been some problems with the 12 to 5V regulator. Specifically if this regulator has the red colour. More than a year ago I am using a custom voltage regulator...

Hello, I am not familiar with 4-20mA current loops but I would do as follows: - connect plus terminal of battery to 12V of multiplexer and the + terminal of your sensor. - connect the - terminal of the sensor to A1. - connect B1 to GND. - use 220 ohms resistor between A1 and B1. When current is 4 mA...

Hello,

Sorry, no.

Regards, Luis

Hello,

Please google CH340 USB driver. Also make sure you are using a USB data cable.

Regards, Luis

Hello,

If you enter simulation mode and Navionics sees the fictional data, then, when data arrives at the inputs, Navionics will see it as well.

Luis

Hello JoeW,

I wonder if you could clarify the problem. I not understanding. Sorry.

Regards, Luis

Hi,

Yes I am in Greece. Tomorrow I will check which wires I connected the AIS to the Nmea4Wifi multiplexer.

Regards, Luis

Hi again, You are connecting yellow to A1 and black to B1. And connecting 12V to the box that receives RF from the sensor. I assume that black is also used as the negative terminal for the current return of the 12v that you supply to the box. If you only connect these 3 wires the box will not receiv...

Hello, I am in Greece and my boat is going to the water this Wednesday. I have limited time but now understand what you have. I just need a screenshot of the multiplexer settings. I need to confirm if you are routing the input port (that you for the wind sensor) to UDP TCP or P5. If an important por...