- (please also read the following topic as the KIT/TH version has been upgraded in October 2022)
- (please also read further to the end as the KIT/TH version has been upgraded in March 2023)
The multiplexer is available in versions built with SMD (Surface Mounting Devices) and TH (Through-Hole) technologies. It can be supplied in 3 versions:
- Nmea3Wifi SMD
- Nmea3Wifi TH
- Nmea3Wifi KIT
The circuit diagrams of the multiplexers can be downloaded from the links at the bottom of this post.
The remaining part of this post is addressed to the builders of the Nmea3Wifi KIT. Kits are supplied with the original Instruction Manual for the Nmea2Wifi multiplexer. We advise you to read that manual as there are many common aspects between the Nmea2Wifi and the Nmea3Wifi Kits. Basically the Nmea3Wifi kit uses a different processor. Instead of the ESP8266 module, the Nmea3Wifi kit uses an ESP32 module developed by Vela Navega. In the following we show the relevant differences to the referred to Instruction Manual. The parts list is as follows:
The PCB (Printed Circuit Board) is shown here (colour could be green):
and the some parts in this KIT (with instructions) are shown in the following picture:
Note that the diodes, LEDs, R4 resistor array and ICs need proper orientation. The diodes have a bar that indicates the cathode. You need to insert them so that the bar that exists in the body of the component coincides with that shown on the PCB. The LEDs have 2 terminals (anode and cathode). The cathode terminal wire is shorter than that of the anode and should go on the lower hole of the PCB orientated as in the picture above. Resistor arrays R2 and R4 have a dot printed in their bodies. The pin near the dot of R4 should go on the hole whose pad is quadrangular. Resistor array R2 can be mounted either way. As for the ICs please follow this picture:
The following pictures (they refer to the Nmea4Wifi multiplexer but they are general) will also give you some ideas on how to assemble the KIT.
Finally note that the ESP32 module is already flashed. It could be the case that the firmware version supplied with the module is not the most recent one. If that is the case it is very easy to do an update.