Hi,
I have a strange problem with my NMEA3wifi.
I connected my VHF/GPS/AIS to P1 using NMEA0183 cable connection. I setup the device to send the sentences in UDP over the wifi on port 2000 and my OpenCPN is detect all sentences (GPS and AIS). See the configuration here :
Then I tried to send to the device the anemometer data via also UDP port 2000 connecting the anemometer to the device through wifi device AP. I see all sentences (GPS, AIS and anemometer) on the configuration page using debug page :
But I don't see anemometer sentences on OpenCPN (which is UDP open on port 2000 and it still see the GPS/AIS sentences).
Any idea what's wrong with my configuration ?
Thanks,
Yann
Problem with UDP transmission
Re: Problem with UDP transmission
Hello,
The multiplexer can not send out on UDP what it receives on UDP. There is no UDP>UDP routing box. Are you using OpenCPN only? As far as i know you could send your wind data by UDP directly to OpenCPN. Or you could route UDP>TCP and create e receiving TCP connection on OpenCPN.
Regards, Luis
The multiplexer can not send out on UDP what it receives on UDP. There is no UDP>UDP routing box. Are you using OpenCPN only? As far as i know you could send your wind data by UDP directly to OpenCPN. Or you could route UDP>TCP and create e receiving TCP connection on OpenCPN.
Regards, Luis