Change in the User Interface
Posted: Thu Oct 17, 2019 1:59 am
Hello,
The following picture shows the new Settings Web Page for the Serial and Wifi ports. The part that respects to Baud Rate (in the Serial ports) and Port Numbers (in the Wifi ports) is the same.
However the multiplexer matrix is more complete. It consists on a set 10 Check Boxes. The first 6 boxes refer the destination of the serial inputs P#1 and P#2. Both inputs can be directed to P#3 or to Wifi using UDP or TCP. The second set of 4 boxes refer to the destination of the Wifi (UDP or TCP) inputs. Note that there are 2^10 (2 to the power of 10) or 1024 different possibilities. Also note that if you set a port number to 0 you disable related check boxes. For example if TCP port number is set to 0, checked boxes "P#1 to TCP", "P#1 to TCP", "TCP to P#3", "TCP to UDP" and "UDP to TCP" will not be accepted. If you check one of those and press SET, it will be automatically unchecked.
Regards, Luis
The following picture shows the new Settings Web Page for the Serial and Wifi ports. The part that respects to Baud Rate (in the Serial ports) and Port Numbers (in the Wifi ports) is the same.
However the multiplexer matrix is more complete. It consists on a set 10 Check Boxes. The first 6 boxes refer the destination of the serial inputs P#1 and P#2. Both inputs can be directed to P#3 or to Wifi using UDP or TCP. The second set of 4 boxes refer to the destination of the Wifi (UDP or TCP) inputs. Note that there are 2^10 (2 to the power of 10) or 1024 different possibilities. Also note that if you set a port number to 0 you disable related check boxes. For example if TCP port number is set to 0, checked boxes "P#1 to TCP", "P#1 to TCP", "TCP to P#3", "TCP to UDP" and "UDP to TCP" will not be accepted. If you check one of those and press SET, it will be automatically unchecked.
Regards, Luis