No WiFi

Discussion and support for the Nmea2Wifi multiplexer - a 2-input Nmea 0183 wifi multiplexer.
Luis Sa
Site Admin
Posts: 847
Joined: Thu May 04, 2017 4:12 am

Re: No WiFi

Post by Luis Sa » Mon Jun 22, 2020 9:40 pm

Hello,

If you can see simulation, it means that you were able to flash the module with the 63 firmware. So I assume the problem is solved!

Regards, Luis

jbonde
Posts: 12
Joined: Sat May 30, 2020 3:51 am

Re: No WiFi

Post by jbonde » Wed Jul 08, 2020 10:03 am

Did a reinstall in the boat and same thing happens. When everything is connected (12V, Seatalk and NMEA inputs) the AP pops up for a while and then disappears. Could there be anything I should check for at the board or the environment that could cause the Esp flash to erase? For your information I have another AP at the boat (different SSID) and it works fine.

jbonde
Posts: 12
Joined: Sat May 30, 2020 3:51 am

Re: No WiFi

Post by jbonde » Tue Jul 28, 2020 2:24 pm

Still no success making it work. Did try to install on another boat but same thing happens. Tried to flash the NMEA2WIFIV63.bin with OTA as well as the ESP8266Flasher_64.exe but the AP disappears when trying to connect. If only the OTA_BLINK.bin is installed it is OK to connect and access the 192.168.4.1:82/update page but this is the far as I can get.

Post Reply