Congratulations on your product.
I want to connect ST60 RAYMARINE with Garmin GPSMAP XSV plotter with NMEA2WIFI.
Following the manual I have connected it as follows:
a.- positive of SEATALK1 in 12V and in A1
b.- negative of SEATALK1 on GND
c.- data cable from SEATALK1 (yellow) to B1
the green LED flashes, as the manual says.
But I have doubts ... I can't see the SEATALK1 data on the plotter. I have configured the NMEA0183 inputs on the Garmin chartplotter as standard.
Following the Garmin manual I connect:
a.- brown wire (Internal port 1 RX (input) on A3
b.- black cable (negative) in B3
But I don't see data on the Garmin chartplotter. Can you help me?
Thanks
Raymarine ST60 to Garmin Plotter 7040XSV
Re: Raymarine ST60 to Garmin Plotter 7040XSV
Hello,
You should not connect B3 to GND. I hope that the P3 driver is not broken.
B3 should only be used if you are sure that the nmea listening device (your Garmin) has a differencial input. So the black cable from Garmin should go GND near B3.
Also you need to check the box to route P1 to P3 (P1>P3). And make sure you are using the right baude rate.
Regards, Luis
You should not connect B3 to GND. I hope that the P3 driver is not broken.
B3 should only be used if you are sure that the nmea listening device (your Garmin) has a differencial input. So the black cable from Garmin should go GND near B3.
Also you need to check the box to route P1 to P3 (P1>P3). And make sure you are using the right baude rate.
Regards, Luis
Re: Raymarine ST60 to Garmin Plotter 7040XSV
Good morning Luis.
I've run the simulation, just like you said, and I can't see the Seatalk1 data from the ST60 on the Garmin chartplotter.
I have tried all possible speeds.
I have verified, in debugging mode, that the NMEA2WIFI correctly sees the seatalk1 signals.
Can I do some other test to check if the A3 output is not damaged?
Thank you
Greetings
I've run the simulation, just like you said, and I can't see the Seatalk1 data from the ST60 on the Garmin chartplotter.
I have tried all possible speeds.
I have verified, in debugging mode, that the NMEA2WIFI correctly sees the seatalk1 signals.
Can I do some other test to check if the A3 output is not damaged?
Thank you
Greetings
Re: Raymarine ST60 to Garmin Plotter 7040XSV
Hello,
You need to set P1>P5 and P2>P5 so that the simulation data also goes to P5. In order to test the hardware, I just made another video shown here.
Hope you solve your setup,
Regards, Luis
You need to set P1>P5 and P2>P5 so that the simulation data also goes to P5. In order to test the hardware, I just made another video shown here.
Hope you solve your setup,
Regards, Luis