Unable to join network “NMEA2WIFI”
Unable to join network “NMEA2WIFI”
Has anyone had problems with their iPad and/or iPhone joining the Wi-Fi network? I’ve tried all manner of settings, resetting the multiplexer and the ipad/phone , mobile data off, etc.. nothing seems to work. Same problem with both.
Re: Unable to join network “NMEA2WIFI”
Hello,
Problem was the multiplexer very close to the VHF rádio.
Luis
Problem was the multiplexer very close to the VHF rádio.
Luis
Re: Unable to join network “NMEA2WIFI”
Mike,
Did Luis's answer help- or do you still have problems?
How far apart and where are the iPhone / VHF / NMEA2WIFi units?
I have Ipad and Iphone and have had them working fine with both NMEA 2 and 4 . So I may be able to help with settings.
Sometimes it does take a few moments for the NMEAxWiFI to appear in the WI-FI settings list.
I find switching off Wifi and then on seems to usually make the iPhone rescan. Ditto the NMEAxWifi. But I assume you have tried this!.
Also do not forget that if the NMEAxWIFI is not connected to a network within 5 minutes of power up, it will switch off the Wi-Fi to save power- as it assumes its just being used for NMEA conversion.
I will try to check back to see any responses!
Cheers
Dagnall
Re: Unable to join network “NMEA2WIFI”
Hello Dagnall,
Yes, we exchanged emails. When the unit was due to return to me, the user just told me that the unit was 15cm near to the VHF radio and placing it a bit apart, everything was fine.
Regards, Luis
Yes, we exchanged emails. When the unit was due to return to me, the user just told me that the unit was 15cm near to the VHF radio and placing it a bit apart, everything was fine.
Regards, Luis
Re: Unable to join network “NMEA2WIFI”
hi,i am currently cruising in the Netherlands and just got my nmea2wifi module
i tried to conect it, first successfully, then i tried to vchsnge the settings - i need a tcp connection to work eith my nv charts app
now i cant connect to the wifimofule snymore, a red led is blinking (probably ais data?)
- how doo i connect , maybe a reset?
- what do i need to do to connect via tcp ?
thank you and best regards, sue
i tried to conect it, first successfully, then i tried to vchsnge the settings - i need a tcp connection to work eith my nv charts app
now i cant connect to the wifimofule snymore, a red led is blinking (probably ais data?)
- how doo i connect , maybe a reset?
- what do i need to do to connect via tcp ?
thank you and best regards, sue
Re: Unable to join network “NMEA2WIFI”
Hello,
Do you see the WiFi network Nmea2Wifi? Can you connect to it? If you say that the red led is blinking that means that the multiplexer is working and receiving a is data.
You can make a factory reset. Press and hold the switch on the PCB. All LEDs will go on. When they go off ( after 3 seconds) you can release the switch.
Hope you can solve your problem.
Regards, Luis
Do you see the WiFi network Nmea2Wifi? Can you connect to it? If you say that the red led is blinking that means that the multiplexer is working and receiving a is data.
You can make a factory reset. Press and hold the switch on the PCB. All LEDs will go on. When they go off ( after 3 seconds) you can release the switch.
Hope you can solve your problem.
Regards, Luis