NEMA2WiFi

Discussion and support for the Nmea2Wifi multiplexer - a 2-input Nmea 0183 wifi multiplexer.
Post Reply
joe.walsh
Posts: 4
Joined: Tue May 31, 2022 8:37 am

NEMA2WiFi

Post by joe.walsh » Tue May 31, 2022 9:53 am

Hi

I have a NEMA2WiFi TH

I have flashed the WiFi module with the latest firmware and tested it powered by USB
It works in so far as I can see the home page at 1892.168.4.1
The Simulation Mode also works to Navionics

When inserted into the main NEMA2WfIF board again both the Home Page and Simulation mode works picked up via Navionics
However, Navionics cannot connect in normal AP mode with nothing connected to a NEMA input, is this normal ?

I am Sending NEMA to A2,B2 form a MAIANA AIS and I do see the LED blink every couple of minutes.

Your help will be appreciated

Ta

JoeW

Luis Sa
Site Admin
Posts: 845
Joined: Thu May 04, 2017 4:12 am

Re: NEMA2WiFi

Post by Luis Sa » Tue May 31, 2022 12:24 pm

Hello JoeW,

I wonder if you could clarify the problem. I not understanding. Sorry.

Regards, Luis

joe.walsh
Posts: 4
Joined: Tue May 31, 2022 8:37 am

Re: NEMA2WiFi

Post by joe.walsh » Tue May 31, 2022 12:31 pm

OK

If I have no nmea signal or fead into the NMEA2WIFI

Will Navionics connect?

Luis Sa
Site Admin
Posts: 845
Joined: Thu May 04, 2017 4:12 am

Re: NEMA2WiFi

Post by Luis Sa » Tue May 31, 2022 5:38 pm

Hello,

If you enter simulation mode and Navionics sees the fictional data, then, when data arrives at the inputs, Navionics will see it as well.

Luis

joe.walsh
Posts: 4
Joined: Tue May 31, 2022 8:37 am

Re: NEMA2WiFi

Post by joe.walsh » Tue May 31, 2022 8:31 pm

Luis

Understood thank you.

I will double check my NMEA source

Thank you

JoeW

Post Reply