Hi
I have a NEMA2WiFi TH
I have flashed the WiFi module with the latest firmware and tested it powered by USB
It works in so far as I can see the home page at 1892.168.4.1
The Simulation Mode also works to Navionics
When inserted into the main NEMA2WfIF board again both the Home Page and Simulation mode works picked up via Navionics
However, Navionics cannot connect in normal AP mode with nothing connected to a NEMA input, is this normal ?
I am Sending NEMA to A2,B2 form a MAIANA AIS and I do see the LED blink every couple of minutes.
Your help will be appreciated
Ta
JoeW
NEMA2WiFi
Re: NEMA2WiFi
Hello JoeW,
I wonder if you could clarify the problem. I not understanding. Sorry.
Regards, Luis
I wonder if you could clarify the problem. I not understanding. Sorry.
Regards, Luis
Re: NEMA2WiFi
OK
If I have no nmea signal or fead into the NMEA2WIFI
Will Navionics connect?
If I have no nmea signal or fead into the NMEA2WIFI
Will Navionics connect?
Re: NEMA2WiFi
Hello,
If you enter simulation mode and Navionics sees the fictional data, then, when data arrives at the inputs, Navionics will see it as well.
Luis
If you enter simulation mode and Navionics sees the fictional data, then, when data arrives at the inputs, Navionics will see it as well.
Luis
Re: NEMA2WiFi
Luis
Understood thank you.
I will double check my NMEA source
Thank you
JoeW
Understood thank you.
I will double check my NMEA source
Thank you
JoeW